Ford F150 Forumz banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello i have ran into a problem in my swap went from 91 5.0 to 84 351w.Everything bolts up and all but i have run into a wall the plug in for my distr. on the wire harness in my 91 is a 6 wire flat plug but the plug for the distr. for the 84 351w is a round 3 wire. I was wondering if there is any way to wire the new distr. 3 wire to work with the harness 6 wire in my 91 cause everything is all in and bolted this is just the last problem...Please help
 

·
Registered
2013 F-150 XLT 4WD with 5L
Joined
·
1,778 Posts
If you still have the PCM installed you may just need to swap out the distributors.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top