Ford F150 Forumz banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I've read the intructions in a Chilton's Repair Manual, but since there are no illustrations, I'm not sure if I'm identifying the correct retaining screws. I can't seem to locate any other pertinent mounting hardware for the lens/cover('95 F-150) other than the two screws at the top of the lens module. After removing those, I can loosen the module but can't figure out how to disengage it enough in order to access the bulb inside. Can anyone help?
 

·
Registered
2013 F-150 XLT 4WD with 5L
Joined
·
1,778 Posts
It looks like a couple of nuts on the back side of the assembly...

 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top